This article tells you about steps by steps of how to concrete basement floor? First, deckstone. The template should be leveled and compressed as close as possible. A gravel bed should be laid over the ground and leveled to provide drainage for any moisture. Sand is the next team and it must also be smoothed. The sand will provide additional material to a flat surface and allow a more even surface where the concrete is poured. Over the sand, thick vinyl slabs are placed.
Next of how to concrete basement floor is, building Forms. Generally, 2×4 inch boards are placed on their sides and placed in a square or rectangle to create the form. Plumb lines are used to ensure that the forms are level. Additional timber is required to level the concrete when poured. Third, pour concrete. Concrete mixes in the required amounts. Concrete comes dry and blends with water to the correct consistency. If a large amount of concrete is required, a concrete mix can be used to mix large portions of concrete. Concrete is poured into the shape of a rail on the truck that can be directed to the right area.
Fill shape to edge with concrete. Buckets are used to spread the concrete around the form. Fourth, the concrete is leveled by pulling a piece of timber over the top of the mold. The concrete is usually leveled further by using towels to ensure a flat, even surface. Fifth, foam plate or insulation board is installed when the concrete is completely dry and set. The curing process of concrete will vary in the time it takes. Depending on how thick the plate is and how large an area it covers. The foam plate is attached directly to the concrete slab and to surrounding walls (at the bottom at least) with special concrete fasteners or screws. And steps by steps of how to concrete basement floor was finished.