How to Tighten Target Home Floor Lamp
Target home floor lamp is a good way to brighten up a living room as they stand on their own and do not need table space. As floor lamps get older, they can become awkward. If encountered, a waving floor lamp could topple and break. An unbalanced floor lamp will also look skewed and produce a slanting beam of light. You can tighten your floor lamp to prevent it from wobbling. Whether it’s loose in the middle of the device or from the bottom, tighten it on your own.
Determine where your lamp is loose. Grasp the lamp at various points and shake it gently to find where it is resolved. Tighten the middle of the target home floor lamp if you find it loose in this area. Floor lamps use pipes that are screwed together to make it high enough to light the entire room. Grasp the tube just below the loose part with your left hand. Grasp the tube over it with your right hand. Holding the base tube tight, turn the top tube clockwise to tighten it.
Skip the unit if you have found that your target home floor lamp is loose on the base. Tip it over so you have access to the bottom of the foot. Be careful not to damage shade or break bulb. Locate the bolt in the middle of the base of the foot. It will be located directly on the other side of the pipes leading up to the lampshade. Tighten the lamp base bolt. Depending on your floor lamp, tighten it with either a wrench or a Star Screwdriver. Turn the bolt clockwise until it feels tight. Turn the table lamp upright.